Cisco TelePresence System Codec C20 Reference Manual page 34

Cisco TelePresence System Codec C20
Contents Introduction
xConfiguration Conference [1..1] MaxTotalReceiveCallRate
This configuration applies when using a video system's built-in MultiSite feature (optional) to host a
multipoint video conference.
Specify the maximum overall receive bit rate allowed. The bit rate will be divided fairly among all
active calls at any time. This means that the individual calls will be up-speeded or down-speeded as
appropriate when someone leaves or enters a multipoint conference, or when a call is put on hold
(suspended) or resumed.
The maximum receive bit rate for each individual call is defined in the Conference
MaxReceiveCallRate setting.
Requires user role: ADMIN
Value space: <64..10000>
Range: Select a value between 64 and 10000.
Example: xConfiguration Conference 1 MaxTotalReceiveCallRate: 9000
xConfiguration Conference [1..1] VideoBandwidth Mode
Set the conference video bandwidth mode.
Requires user role: ADMIN
Value space: <Dynamic/Static>
Dynamic: The available transmit bandwidth for the video channels are distributed among the
currently active channels. If there is no presentation, the main video channels will use the
bandwidth of the presentation channel.
Static: The available transmit bandwidth is assigned to each video channel, even if it is not active.
Example: xConfiguration Conference 1 VideoBandwidth Mode: Dynamic
xConfiguration Conference [1..1] VideoBandwidth MainChannel Weight
The available transmit video bandwidth is distributed on the main channel and presentation channel
according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel
weight is 2 and the presentation channel weight is 1, then the main channel will use twice as much
bandwidth as the presentation channel.
Requires user role: ADMIN
Value space: <1..10>
Range: 1 to 10.
Example: xConfiguration Conference 1 VideoBandwidth MainChannel Weight: 5
Codec C20 API Reference Guide TC7.0, JANUARY 2014.
D14869.11
About the API xConfiguration xConfiguration
xConfiguration Conference [1..1] VideoBandwidth PresentationChannel Weight
xConfiguration Conference [1..1] Presentation Policy
xConfiguration Conference [1..1] Presentation RelayQuality
xConfiguration Conference [1..1] Presentation OnPlacedOnHold
34
xCommand
The available transmit video bandwidth is distributed on the main channel and presentation channel
according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel
weight is 2 and the presentation channel weight is 1, then the main channel will use twice as much
bandwidth as the presentation channel.
Requires user role: ADMIN
Value space: <1..10>
Range: 1 to 10.
Example: xConfiguration Conference 1 VideoBandwidth PresentationChannel Weight: 5
Control how the presentation service is to be performed.
Requires user role: ADMIN
Value space: <LocalRemote/LocalOnly>
LocalRemote: The presentation will be shown locally and sent to remote side.
LocalOnly: The presentation will only be shown locally.
Example: xConfiguration Conference 1 Presentation Policy: LocalRemote
Not applicable in this version.
Define whether or not to continue sharing a presentation after the remote site has put you on hold.
Requires user role: ADMIN
Value space: <Stop/NoAction>
Stop: The video system stops the presentation sharing when the remote site puts you on hold. The
presentation will not continue when the call is resumed.
NoAction: The video system will not stop the presentation sharing when put on hold. The
presentation will not be shared while you are on hold, but it will continue automatically when the
call is resumed.
Example: xConfiguration Conference 1 Presentation OnPlacedOnHold: NoAction
API Reference Guide
xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.