Cisco TelePresence SX20 Codec Reference Manual page 84

Cisco TelePresence SX20 Codec
Contents Introduction
xCommand Call Disconnect
Disconnect a call. The CallID is returned when the xCommand Dial command is run. During the call
you can run the xStatus Call command to see the CallId.
Requires user role: USER
Parameters:
CallId(r): <0..65534>
Example:
xCommand Call Disconnect CallId:17
OK
*r DisconnectCallResult (status=OK):
** end
xCommand Call DisconnectAll
Disconnect all active calls.
Requires user role: USER
Example:
xCommand Call DisconnectAll
OK
*r DisconnectAllResult (status=OK):
** end
xCommand Call Hold
Put a call on hold. The CallID is returned when the xCommand Dial command is run. During the call
you can run the xStatus Call command to see the CallId.
Requires user role: USER
Parameters:
CallId(r): <0..65534>
Reason(o): <Conference/Transfer/Other>
Example:
xCommand Call Hold CallId:19
OK
*r CallHoldResult (status=OK):
** end
SX20 Codec API Reference Guide TC7.0, JANUARY 2014.
D14949.08
About the API xConfiguration
xCommand Call Join
xCommand Call Resume
84
xCommand xCommand
Join all existing calls, active and on hold. For this command to work, you have to configure
Multiway™ first, see xConfiguration NetworkServices MultiWay Address and xConfiguration
Conference 1 Multipoint Mode.
Requires user role: USER
Parameters:
CallId(r): <0..65534>
Example:
xCommand Call Join
OK
*r CallJoinResult (status=OK):
** end
Resume a call that have been put on hold. The CallID is returned when the xCommand Dial
command is run. During the call you can run the xStatus Call command to see the CallId.
Requires user role: USER
Parameters:
CallId(r): <0..65534>
Example:
xCommand Call Resume CallId:19
OK
*r CallResumeResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2014 Cisco Systems, Inc. All rights reserved.