Cisco TelePresence SX20 Codec Reference Manual page 111

Cisco TelePresence SX20 Codec
Contents Introduction
SystemUnit commands
xCommand SystemUnit OptionKey Add
Add an option key to support additional features.
Requires user role: ADMIN
Parameters:
Key(r): <S: 16, 24>
Example:
xCommand SystemUnit OptionKey Add Key:******************
*r OptionKeyResult (status=OK):
** end
xCommand SystemUnit OptionKey RemoveAll
Removes all Option keys.
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
Example:
xCommand SystemUnit OptionKey RemoveAll Confirm: Yes
*r OptionKeyResult (status=OK):
** end
xCommand SystemUnit ReleaseKey Add
Add the software release key. Used to enable new software (applicable for main software releases).
Requires user role: ADMIN
Parameters:
Key(r): <S: 16, 24>
Example:
xCommand SystemUnit ReleaseKey Add Key:******************
*r ReleaseKeyResult (status=OK):
** end
SX20 Codec API Reference Guide TC7.0, JANUARY 2014.
D14949.08
About the API xConfiguration
xCommand SystemUnit ReleaseKey RemoveAll
xCommand SystemUnit AdminPassword Set
xCommand SystemUnit Diagnostics Run
111
xCommand xCommand
Removes all Release keys.
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
Example:
xCommand SystemUnit ReleaseKey RemoveAll Confirm: Yes
*r ReleaseKeyResult (status=OK):
** end
Set an administrator password to restrict access the codec. After a restart of the codec this
password also applies to the web interface.
Requires user role: ADMIN
Parameters:
Password(r): <S: 0, 64>
Example:
xCommand SystemUnit AdminPassword Set Password:***********
*r AdminPasswordSetResult (status=OK):
** end
This command runs all self-diagnostics commands on the system.
Requires user role: ADMIN
Parameters:
ResultSet(o): <Alerts/All/None>
Example:
xCommand SystemUnit Diagnostics Run
*r DiagnosticsResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2014 Cisco Systems, Inc. All rights reserved.