Cisco TelePresence SX20 Codec Reference Manual page 32

Cisco TelePresence SX20 Codec
Contents Introduction
xConfiguration Cameras Camera [1] MotorMoveDetection
This setting applies only when using a Cisco TelePresence PrecisionHD 1080p12x camera.
If adjusting the camera position by hand you can configure whether the camera should keep its new
position or return to the preset or position it had before.
Requires user role: ADMIN
Value space: <Off/On>
Off: When the camera position is adjusted manually the camera will keep this position until
adjusted again. WARNING: If moving the camera by hand, the camera will not register the new pan
and tilt values since there is no position feedback. This will result in wrong pan and tilt values when
recalling the camera presets subsequently.
On: When the camera position is adjusted manually, or the camera detects that the motors have
moved, it will first re-initialize (i.e. go to default position) then return to the preset/position it had
before the camera was adjusted.
Example: xConfiguration Cameras Camera 1 MotorMoveDetection: Off
xConfiguration Cameras Camera [1] Whitebalance Mode
Set the camera whitebalance mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera will continuously adjust the whitebalance depending on the camera view.
Manual: Enables manual control of the camera whitebalance. The whitebalance level is set using
the Cameras Camera Whitebalance Level setting.
Example: xConfiguration Cameras Camera 1 Whitebalance Mode: Auto
xConfiguration Cameras Camera [1] Whitebalance Level
Set the whitebalance level. Requires the Camera Whitebalance Mode to be set to manual.
Requires user role: ADMIN
Value space: <1..16>
Range: Select a value from 1 to 16.
Example: xConfiguration Cameras Camera 1 Whitebalance Level: 1
SX20 Codec API Reference Guide TC7.0, JANUARY 2014.
D14949.08
About the API xConfiguration xConfiguration
xConfiguration Cameras Camera [1] DHCP
32
xCommand
Applies to cameras which support DHCP over LAN. When set, the command enables support for
software upgrade of daisy chained cameras.
Requires user role: ADMIN
Value space: <Off/On>
Off: When the camera is not connected to a LAN, set to Off to disable DHCP.
On: Set to On to enable DHCP for the camera. The camera is automatically re-booted, and after
re-boot the camera's DHCP function will force start of MAC and IP address retrieval. To see the
result, you can run the following API command: "xStatus Camera". When the camera no longer is
connected to a LAN, set to Off.
Example: xConfiguration Cameras Camera 1 DHCP: Off
API Reference Guide
xStatus Appendices
Copyright © 2014 Cisco Systems, Inc. All rights reserved.