Audio Commands - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec
Contents Introduction

Audio commands

xCommand Audio Microphones Mute
Mute all microphones.
Requires user role: USER
Example:
xCommand Audio Microphones Mute
*r AudioMicrophonesMuteResult (status=OK):
** end
xCommand Audio Microphones Unmute
Unmute microphones.
Requires user role: USER
Example:
xCommand Audio Microphones Unmute
*r AudioMicrophonesUnmuteResult (status=OK):
** end
xCommand Audio Sound Play
Play a specified audio sound.
Requires user role: USER
Parameters:
Sound(r): <Bump/Busy/CallDisconnect/CallInitiate/CallWaiting/Dial/KeyInput/KeyTone/Nav/
NavBack/Notification/OK/PresentationConnect/Ringing/SpecialInfo/TelephoneCall/VideoCall/
Volume>
Loop: <On/Off>
Example:
xCommand Audio Sound Play Sound: Ringing
*r AudioSoundPlayResult (status=OK):
** end
SX20 Codec API Reference Guide TC7.0, JANUARY 2014.
D14949.08
About the API xConfiguration
xCommand Audio Sound Stop
xCommand Audio VUMeter Start
xCommand Audio VUMeter Stop
80
xCommand xCommand
Stop playing audio sound.
Requires user role: USER
Example:
xCommand Audio Sound Stop
*r AudioSoundStopResult (status=OK):
** end
Start collecting VU meter information for connector given by type and ID.
Requires user role: USER
Parameters:
ConnectorType(r): <HDMI/Line/Microphone>
ConnectorId(r): <1..4>
Example:
xCommand Audio VUMeter Start ConnectorType: Microphone ConnectorId: 1
*r AudioVumeterStartResult (status=OK):
** end
Stop collecting VU meter information for connector given by type and ID.
Requires user role: USER
Parameters:
ConnectorType(r): <HDMI/Line/Microphone>
ConnectorId(r): <1..4>
Example:
xCommand Audio VUMeter Stop ConnectorType: Microphone ConnectorId: 1
*r AudioVumeterStopResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2014 Cisco Systems, Inc. All rights reserved.