Cisco TelePresence SX20 Codec Reference Manual page 31

Cisco TelePresence SX20 Codec
Contents Introduction
xConfiguration Cameras Camera [1] Flip
With Flip mode (vertical flip) you can flip the image upside down.
Requires user role: ADMIN
Value space: <Auto/Off/On>
Auto: When the camera is placed upside down the image is automatically flipped upside down.
This setting will only take effect for a camera that automatically detects which way it is mounted.
Off: Display the video on screen the normal way.
On: When enabled the video on screen is flipped. This setting is used when a camera is mounted
upside down, but cannot automatically detect which way it is mounted.
Example: xConfiguration Cameras Camera 1 Flip: Off
xConfiguration Cameras Camera [1] Focus Mode
Set the camera focus mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera will auto focus once a call is connected, as well as after moving the camera
(pan, tilt, zoom). The system will use auto focus only for a few seconds to set the right focus; then
auto focus is turned off to prevent continuous focus adjustments of the camera.
Manual: Turn the autofocus off and adjust the camera focus manually.
Example: xConfiguration Cameras Camera 1 Focus Mode: Auto
xConfiguration Cameras Camera [1] Gamma Mode
Applies to cameras which support gamma mode. Gamma describes the nonlinear relationship
between image pixels and monitor brightness. The Cisco TelePresence PrecisionHD 720p camera
supports gamma mode. The PrecisionHD 1080p camera does not support gamma mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref: Cameras
Camera [1..n] Gamma Level.
Example: xConfiguration Cameras Camera 1 Gamma Mode: Auto
SX20 Codec API Reference Guide TC7.0, JANUARY 2014.
D14949.08
About the API xConfiguration xConfiguration
xConfiguration Cameras Camera [1] Gamma Level
xConfiguration Cameras Camera [1] IrSensor
xConfiguration Cameras Camera [1] Mirror
31
xCommand
By setting the Gamma Level you can select which gamma correction table to use. This setting may
be useful in difficult lighting conditions, where changes to the brightness setting does not provide
satisfactory results. Requires the Gamma Mode to be set to Manual.
Requires user role: ADMIN
Value space: <0..7>
Range: Select a value from 0 to 7.
Example: xConfiguration Cameras Camera 1 Gamma Level: 0
The IR sensor LED is located in the front of the camera and flickers when the IR sensor is activated
from the remote control. Both the Codec C Series and PrecisionHD camera have IR sensors, and
only one of them needs to be enabled at the time.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the IR sensor on the camera.
On: Enable the IR sensor on the camera.
Example: xConfiguration Cameras Camera 1 IrSensor: On
With Mirror mode (horizontal flip) you can mirror the image on screen.
Requires user role: ADMIN
Value space: <Auto/Off/On>
Auto: When the camera is placed upside down the image is automatically mirrored. Use this
setting with cameras that can be mounted upside down, and that can auto detect that the camera
is mounted upside down.
Off: See the self-view in normal mode, that is the experience of self-view is as seeing yourself as
other people see you.
On: See the self-view in mirror mode, that is the self-view is reversed and the experience of self-
view is as seeing yourself in a mirror.
Example: xConfiguration Cameras Camera 1 Mirror: Off
API Reference Guide
xStatus Appendices
Copyright © 2014 Cisco Systems, Inc. All rights reserved.