Xstatus Systemunit State Numberofinprogresscalls; Xstatus Systemunit State Subsystem Application; Xstatus Systemunit Contactinfo; Xstatus Systemunit Contactname - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec
Contents Introduction

xStatus SystemUnit State NumberOfInProgressCalls

Shows the number of calls in progress.
Value space of the result returned:
<0..5>
Example:
xStatus SystemUnit State NumberOfInProgressCalls
*s SystemUnit State NumberOfInProgressCalls: 0
** end

xStatus SystemUnit State Subsystem Application

Shows the status of the sub system application.
Initialized: The sub-system application is initialized.
Initializing: The sub-system application is initializing.
Value space of the result returned:
<Initialized/Initializing>
Example:
xStatus SystemUnit State Subsystem Application
*s SystemUnit State Subsystem Application: Initialized
** end

xStatus SystemUnit ContactInfo

Returns the system's active contact information. This is the address which is used to reach this
system.
Value space of the result returned:
<String>
Example:
xStatus SystemUnit ContactInfo
*s SystemUnit ContactInfo: "firstname.lastname@company.com"
** end
SX20 Codec API Reference Guide TC7.0, JANUARY 2014.
D14949.08
About the API xConfiguration

xStatus SystemUnit ContactName

xStatus SystemUnit Notifications Notification [n] Type

179
xCommand
Returns the system's active contact name. The result depends on which protocol, if any, the system
is registered on. Unlike Contact Info, Contact Name is not configurable and is automatically set by
the system.
Value space of the result returned:
<String>
Example:
Not registered to a protocol
xStatus SystemUnit ContactName: "192.0.2.0"
Example 2: Registered on SIP
xStatus SystemUnit ContactName: "1234@192.0.2.0"
Lists the system notification types. Notifications are issued e.g. when a system is rebooted because
of a software upgrade, or when a factory reset is performed.
FactoryResetOK: This value is returned after a successful factory reset.
FactoryResetFailed: This value is returned after a failed factory reset attempt.
SoftwareUpgradeOK: This value is returned after a successful software upgrade.
SoftwareUpgradeFailed: This value is returned after a failed software upgrade attempt.
RebootRequired: This value is returned when a reboot is required.
Other: This value is returned for any other notifications.
All the notifications can be removed from the list by issuing the xCommand SystemUnit Notifications
RemoveAll command.
Value space of the result returned:
<FactoryResetOK, FactoryResetFailed, SoftwareUpgradeOK, SoftwareUpgradeFailed,
RebootRequired, Other>
Example:
xStatus SystemUnit Notifications Notification 1 Type
*s SystemUnit Notifications Notification 1 Type: SoftwareUpgradeOK
** end
API Reference Guide
xStatus xStatus Appendices
Copyright © 2014 Cisco Systems, Inc. All rights reserved.