Table 54. Snmp Traps - D-Link Unified Access System DWS-3000 Series User Manual

Table 54 describes the events that generate SNMP traps. All traps are disabled by default.

Table 54. SNMP Traps

Field Description
AP Failure Traps If you enable this field, the SNMP agent sends a trap if an AP fails to
associate or authenticate with the switch.
AP State Change If you enable this field, the SNMP agent sends a trap for one of the following
Traps reasons:
•
•
•
•
Client Failure If you enable this field, the SNMP agent sends a trap if a wireless client fails
Traps to associate or authenticate with an AP that is managed by the switch.
Client State If you enable this field, the SNMP agent sends a trap for one of the following
Change Traps reasons associated with the wireless client:
•
•
•
Peer Switch Traps If you enable this field, the SNMP agent sends a trap for one of the following
reasons associated with a peer switch
•
•
•
RF Scan Traps If you enable this field, the SNMP agent sends a trap when the RF scan
detects a new AP, wireless client, or ad-hoc client.
Rogue AP Traps If you enable this field, the SNMP agent sends a trap when the switch
discovers a rogue AP.
Wireless Status If you enable this field, the SNMP agent sends a trap if the operational status
Traps of the D-Link WLAN Controller Switch changes or of any of the following
databases or lists has reached the maximum number of entries:
•
•
•
•
•
•
•
Managed AP Discovered
Managed AP Failed
Managed AP Unknown Protocol Discovered
Managed AP Load Balancing Utilization Exceeded
Client Association Detected
Client Disassociation Detected
Client Roam Detected
Peer Switch Discovered
Peer Switch Failed
Peer Switch Unknown Protocol Discovered
Managed AP database
AP Neighbor List
Client Neighbor List
AP Authentication Failure List
RF Scan AP List
Client Association Database
Client Authentication Failure List
8 Configuring Advanced Settings
Enabling SNMP Traps 155