Performing Advanced Access Point Management; Table 20. Ap Upgrade Status - D-Link Unified Access System DWS-3000 Series User Manual

D-Link Unified Access System User Manual
Table 20

Table 20. AP Upgrade Status

Field
Status
Download Count
Success Count
Failure Count
A table also appears and lists each AP, its download status, and the software version it is
downloading. The status for an individual AP can have one of the following values:
• Requested—Download has been requested for this AP.
• Pending—Download is planned for this AP, but the AP is not in the current download
group, so it hasn't been told to start the download yet.
• Downloading—The AP has been told to download the code.
• Success—The AP reported successful code download.
• Failure—The AP reported a failed code download.

Performing Advanced Access Point Management

When the D-Link Access Point is in Managed mode, remote access to the AP is disabled.
However, you can enable Telnet access by enabling the Debug feature on the AP
112 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
describes the fields that appear after you start the AP upgrade process.
Description
This field shows the status of the upgrade process for all APs:
• Not Started—The WCS has not started the download process.
• Requested—A request to download AP software has been made, but the
switch has not done any downloads.
• Success—Download completed successfully on all APs. An AP reports
a successful download to the switch after the software transfers from the
TFTP server to the AP and the code checksum is good. The code must
also match the intended hardware platform.
• Partial-Success—Download worked on some APs, but failed on others.
A table lists each AP and its individual status so that you can see which
APs failed to upgrade.
• Failure—Download failed on all APs. A software download fails if the
AP reports a software download failure due to an inability to contact the
TFTP server or find the upgrade file, or if the AP loses connectivity with
the switch.
The number in this field shows the number of managed APs to download
software in the current download request. If you selected All for the managed
APs to upgrade, the download count shows the number of managed APs at
the time the download request was started. The value is 1 if only one AP is
being updated.
The number in this field shows the number of APs that have successfully
downloaded the new code. This value starts with 0 at the beginning of the
download and increases by one for every AP that successfully downloaded
the code.
The number in this field shows the number of APs that failed to download
the new code. This value starts with 0 at the beginning of the download and
increases by one for every AP that failed to downloaded the code.