Connecting To The External Redundant Power System; Connecting The Switch; Figure 24. Dws-3026 With Optional Dem-410X Module Installed; Figure 25. Rps Connector - D-Link Unified Access System DWS-3000 Series User Manual

D-Link Unified Access System User Manual
Now tighten the two screws at adjacent ends of the module into the available screw holes on
the Switch. The upgraded Switch is now ready for use.

Figure 24. DWS-3026 with optional DEM-410X module installed

Connecting to the External Redundant Power System

The Switch supports an external redundant power system (RPS). The diagrams below
illustrate a proper RPS power connection to the Switch. Please consult the documentation for
information on power cabling and connectors and setup procedure.

Figure 25. RPS Connector

DWS-3026
DPS-600

Connecting the Switch

This section describes how to connect the following nodes:
• Switch to the network
• AP directly to the Switch
• AP to the Switch through the L2/L3 network
• Switch through the 10GB uplink to the network core
NOTE:
46 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
All 24 high-performance N-Way Ethernet ports can support both MDI-II and
MDI-X connections.
RPS Connector