Enabling The Wlan Features On The Switch; Table 3. Basic Wireless Global Configuration - D-Link Unified Access System DWS-3000 Series User Manual

D-Link Unified Access System User Manual
To view the network information, enter
6. To save these changes so they are retained during a switch reset, enter the following
command:
write
Once the D-Link WLAN Controller Switch is connected to the network, you can use the IP
address for remote access to the switch by using a Web browser or through Telnet or SSH.

Enabling the WLAN Features on the Switch

In order for the WCS to be able to discover and manage access points, the WLAN switch and
its operational status must both be enabled. However, before you enable the WLAN switch, set
the correct country code for the switch so that the access points can only operate in the modes
permitted in your country. The default country code is US for operation in the United States.
To set the country code and enable the switch by using the Web interface, click
Administration > Basic Setup.
Configuration page.
NOTE: Wireless features are available under the WLAN tab on the navigation menu.
NOTE: Most configuration pages have a Submit button, which applies the changes to

Table 3. Basic Wireless Global Configuration

Field
Enable WLAN
Switch
WLAN Switch
Operational Status
52 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
the running configuration but does not save them to non-volatile memory
(NVRAM). To make the changes permanent so they persist across a reboot,
click the Tool, then click Save Changes to navigate to the appropriate page.
You can also use the
write
Description
Check the box to enable WLAN switching functionality on the system. Clear
the check box to administratively disable the WLAN switch.
If you clear the check box, all peer switches and APs that are associated with
this switch are disassociated.
Disabling the WLAN switch does not affect non-WLAN features on the
switch, such as VLAN or STP functionality.
Shows the operational status of the switch. The status can be one of the
following values:
• Enabled
• Enable-Pending
• Disabled
• Disable-Pending
If the status is pending, click Refresh to refresh the screen.
show network
Table 3 describes the fields on the Wireless Global
command in Privileged Exec mode.
.