Configuring Wireless Radio Settings; Table 8. Mac Authentication; Figure 35. Mac Access Control - D-Link Unified Access System DWS-3000 Series User Manual

D-Link Unified Access System User Manual
On the AAA/RADIUS tab, you can also configure a global list containing the MAC addresses
of wireless clients to allow or deny access to APs. The list only applies to profiles that use
local MAC Authentication, which is an SSID setting. MAC Authentication is disabled by
default. For information about enabling MAC Authentication, see
Network"
If you select Allow as the default action, the wireless clients you add to the Allow MAC List
can connect to the AP, and all other wireless clients are denied. If you select Deny as the
default action, the wireless clients with the MAC addresses that you add to the Deny MAC list
cannot associate with the AP.
NOTE: The MAC list label updates depending on the default action you select.

Figure 35. MAC Access Control

To add a wireless client to the MAC Authentication list, enter the MAC address of the client in
the MAC Address field and click Add. You must click Submit to apply the changes.
The following table describes the MAC Authentication fields in more detail.

Table 8. MAC Authentication

Field
Default Action
MAC List
MAC Address

Configuring Wireless Radio Settings

The DWL-3500AP supports one radio that operates in IEEE 802.11g mode. The DWL-
8500AP supports two radios: Radio 1 operates in IEEE 802.11a mode, and Radio 2 operates in
IEEE 802.11g mode.
80 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
on page 87.
Description
The default action is the action that is taken for unknown MAC addresses of
wireless clients that attempt to associate with an access point.
• Allow—Only the clients you explicitly add to this list are allowed access
to APs that use MAC Authentication.
• Deny—Only the clients you explicitly add to this list are denied access
to APs that use MAC Authentication.
This list shows the MAC address of the wireless clients that have already
been added to the list of wireless clients to allow or deny access to the APs.
Enter the MAC address of the wireless client to allow or deny access to all
APs that use this profile.
Allows only MAC
addresses that
appear in the list
Denies only MAC
addresses that
appear in the list
"Configuring the Default