Discovering Access Points And Peer Switches; Understanding The Discovery Methods; Table 5. Ap Vlan Commands - D-Link Unified Access System DWS-3000 Series User Manual

Table 5. AP VLAN Commands

Action
View management interface
information, including the VLAN ID
Set the management VLAN ID
View untagged VLAN information
Enable the untagged VLAN
Disable the untagged VLAN
Set the untagged VLAN ID

Discovering Access Points and Peer Switches

The D-Link WLAN Controller Switch can discover, validate, authenticate, or monitor the
following system devices:
• Peer wireless switches
• D-Link Access Points
• Wireless clients
• Rogue APs
• Rogue wireless clients.
This section describes the procedures you use to discover D-Link Access Points and other
D-Link WLAN Controller Switches. For information about the discovery of wireless clients,
see "Monitoring Associated Client Information"
discovering rogue devices, see
In order for the WCS to discover other WLAN devices and establish communication with
them, the devices must have their own IP address, must be able to find other WLAN devices,
and must be compatible.
When the D-Link WLAN Controller Switch discovers and validates D-Link Access Points, the
switch takes over the management of the AP. The default AP Profile settings are listed in
Appendix A.
For information about how to change the AP Profile settings, see Chapter 5,
Access Point Settings"

Understanding the Discovery Methods

The WCS and AP have multiple ways of discovering each other. The following examples
describe different ways the discovery can occur.
Example 1: L2 Discovery
In Figure 30, the AP and WCS are directly connected. The devices are in the same layer 2
broadcast domain and use the default VLAN settings. After both devices acquire an IP
Command
get management
set management vlan-id <1-4096>
get untagged-vlan
set untagged-vlan status up
set untagged-vlan status down
set untagged-vlan vlan-id <1-4096>
"Monitoring Rogue and RF Scan Access Points"
on page 77.
Discovering Access Points and Peer Switches
4 Installing the D-Link Unified Access System
on page 138. For more information about
on page 136.
"Configuring
57