Installing The D-Link Unified Access System; System Deployment Overview - D-Link Unified Access System DWS-3000 Series User Manual

Installing the D-Link Unified Access
System
This chapter contains the following sections to help you install your D-Link Unified Access
System network:
•

System Deployment Overview

• Connecting the Switch to the Network
• Enabling the WLAN Features on the Switch
• Preparing the Access Points
• Discovering Access Points and Peer Switches
• Authenticating and Validating Access Points
System Deployment Overview
To setup and deploy the D-Link Unified Access System solution, use the following general
steps:
1. Plan the WLAN network topology.
Decide where to locate each access point to maximize accessibility to the WLAN by
wireless clients and to minimize radio frequency (RF) interference by other access points.
You should also determine how to integrate the D-Link WLAN Controller Switch into
your existing network topology. For more information about planning the WLAN
topology, see
2. Install and configure the D-Link WLAN Controller Switch.
To install and configure the switch, you need a serial connection to the switch, or you must
connect to the switch from a host in the same subnet as the switch default IP address
(10.10.10.90/8). From the initial connection to the switch, you can configure basic
network information or enable the DHCP client on the switch to acquire this information
automatically.
3. Enable the WLAN switch function and assign an IP address to the WLAN switch
interface.
The WLAN features on the switch are disabled by default. You must enable the WLAN
"WLAN Topology Considerations" on page 32.
System Deployment Overview
4
49