Using The Local Database For Ap Validation; Figure 34. Requiring Ap Authentication - D-Link Unified Access System DWS-3000 Series User Manual

D-Link Unified Access System User Manual
To enable AP authentication on the WCS, click Administration > Basic Setup. From the
Global tab, check the AP Authentication box, then click Submit to apply your changes.

Figure 34. Requiring AP Authentication

To enable AP authentication from the CLI, access Wireless Config mode and enable
authentication:
(switch-prompt) >enable
Password:
(switch-prompt) #config
(switch-prompt) (Config)#wireless
(switch-prompt) (Config-wireless)#ap authentication

Using the Local Database for AP Validation

To use the local Valid AP database, set the AP Validation to local, add APs to the database,
and configure the settings for the APs in the database. All of the configuration takes place on
the switch.
To set up the local database for AP Validation, use the following steps:
1. From the Administration > Basic Setup > Global page, make sure AP Validation is set
to Local, which is the default.
2. Click Submit if you made any changes.
3. Click the Valid AP tab.
72 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.