Table 63. L3 Tunnel Status Values - D-Link Unified Access System DWS-3000 Series User Manual

D-Link Unified Access System User Manual
10. Enter CTRL + Z to exit to Privileged EXEC mode and view the network configuration to
make sure the L3 Tunnel Status is listed as "Configured" and to confirm that other
network settings are correct.
(switch-prompt) #show wireless network 3
Network ID..................................... 3
SSID........................................... L3 Tunnel
Default VLAN................................... 1
Hide SSID...................................... Disable
Deny Broadcast................................. Disable
L3 Tunnel Mode................................. Enable
L3 Tunnel Status............................... Configured
L3 Tunnel Subnet IP............................ 192.168.60.0
L3 Tunnel Subnet Mask.......................... 255.255.255.0
Security Mode.................................. WPA Enterprise
MAC Authentication............................. Disable
RADIUS Use AP Profile.......................... Enable
RADIUS Server IP............................... 0.0.0.0
RADIUS Secret Configured....................... No
RADIUS Accounting.............................. Disable
WPA Versions................................... WPA/WPA2
WPA Ciphers.................................... TKIP
WPA Key Type................................... ASCII
WPA Key........................................
WPA2 Pre-Authentication........................ Enable
WPA2 Pre-Authentication Limit (minutes)........ 0
WPA2 Pre-Authentication Timeout (minutes)...... 0
--More-- or (q)uit
WPA2 Key Forwarding............................ Enable
WPA2 Key Caching Holdtime (minutes)............ 10
WEP Authentication Type........................ Open System
WEP Key Type................................... HEX
WEP Key Length (bits).......................... 128
WEP Transfer Key Index......................... 1
WEP Key 1......................................
WEP Key 2......................................
WEP Key 3......................................
WEP Key 4......................................
An important value to note is the L3 Tunnel Status value. The following table lists the
possible values and explains what they mean.

Table 63. L3 Tunnel Status Values

L3 Tunnel Status
None
Configured
194 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
The status might be None for one of the following reasons:
• The WLAN Operational Status is disabled
• L3 Tunnel is Disabled
• The network is not associated with any AP profiles. If you create
or edit a network and configure L3 Tunneling, but there are no
VAPs on any AP Profiles that use the network, the status is None.
The L3 Tunnel is configured and ready to be applied to the APs that
use this profile.
Description