Configuring Aaa And Radius Settings; Table 7. Global Radius Server - D-Link Unified Access System DWS-3000 Series User Manual

address according to the validation mode (local or RADIUS) as long as the AP is enabled for
Managed Mode and has been authentication (if required). Once the AP is verified, it becomes
managed by the switch.
If an AP is discovered and its MAC address is not found in the Valid AP database or the AP
fails to authenticate, the switch adds an entry to the AP failure list. If you use the local Valid
AP database, you can add the failed AP to the Valid AP database directly from the AP
Authentication Failures page.
The Valid AP database stores additional information about the AP along with its MAC address
such as the AP mode, local authentication password, and the AP profile that the access point
uses. You can also manually set the channel and RF signal transmit power level for an
individual AP, which overrides the channel and power settings in the AP profile.

Configuring AAA and RADIUS Settings

In the D-Link Unified Access System, you can use a RADIUS server for the following
functions:
• Management of client-to-AP authentication and accounting
• Management of AP-to-Switch authentication and accounting
• Database for AP settings
The information in this section applies to the client-to-AP authentication and accounting
management. For information about AP-to-switch management, see
Database for AP Validation"
settings in the RADIUS server, see Appendix B,
on page 179.
The RADIUS server that you configure from the Administration > Basic Setup >
AAA/RADIUS tab is the RADIUS server for the default AP profile. For each network, you
can configure a unique RADIUS server or use the default RADIUS server.
Table 7 describes the fields you can configure for the default AP profile RADIUS server.

Table 7. Global RADIUS Server

Field
IP Address
Secret
Accounting
NOTE: If you access the RADIUS and MAC Authentication configuration
information from the AP Profile page, the Profile Name field also appears. To
rename the profile, delete the existing name and enter the new name in the
field, then click Submit.
on page 74. For information about how to set AP database
Description
The RADIUS IP is the IP address of the
authentication.
The RADIUS Secret is the shared secret key for the RADIUS server. Click
the Edit check box to enter a secret. The text you enter will be displayed as
"*" characters to prevent others from seeing the RADIUS key as you type.
RADIUS Accounting allows you to track and measure the resources a
particular user has consumed such as system time, amount of data
transmitted and received, and so on.
5 Configuring Access Point Settings
"Using the RADIUS
"Configuring the External RADIUS Server"
RADIUS server the switch uses for
Configuring AAA and RADIUS Settings 79