Configuring Global Settings; Table 53. General Global Configurations; Figure 70. Global Configuration - D-Link Unified Access System DWS-3000 Series User Manual

• Associated-Modified—The profile has been modified since it was applied to one or more
associated APs; the profile must be re-applied for the changes to take effect.
• Apply Requested—After you select a profile and click Apply, the screen refreshes and
shows that an apply has been requested.
• Apply In Progress—The profile is being applied to all APs that use this profile. During
this process the APs reset, and all wireless clients are disassociated from the AP.
• Configured—The profile is configured, but no APs managed by the switch currently use
this profile.
NOTE: You associate a profile with an AP in the Valid AP database.

Configuring Global Settings

The fields on the Administration > Advanced Configuration > Global > General tab are
settings that apply to the D-Link WLAN Controller Switch.

Figure 70. Global Configuration

Table 53 describes the fields on the Wireless Global Configuration page.

Table 53. General Global Configurations

Field
Peer Group ID
Client Roam
Timeout
Ad Hoc Client
Status
Description
In order to support larger networks, you can configure wireless switches as
peers, with up to 4 switches in a peer group. Peer switches share some
information about APs and allow L3 roaming among them.
Peers are grouped according to the Group ID.
This value determines how long to keep an entry in the Associated Client
Status list after a client has disassociated. Each entry in the status list shows
an age, and when the age reaches the value you configure in the timeout field,
the entry is deleted.
This value determines how long to keep an entry in the Ad Hoc Client Status
list. Each entry in the status list shows an age, and when the age reaches the
value you configure in the timeout field, the entry is deleted.
8 Configuring Advanced Settings
Configuring Global Settings 153