Reconnecting The Power; How To Reconnect Ac-Input Power Supply Unit - Cisco SFE2000P Installation And Configuration Manual

Reconnecting the Power

SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Grasp the power supply unit handle with one hand and place your other hand underneath the power
Step 1
supply for support.
Fit the groove in the side of the new power supply module into the guide in the chassis.
Step 2
Gently, but firmly, slide the module into the chassis until its faceplate is flush with the chassis rear panel.
Step 3
When inserting a power supply into the SCE 2000 platform, do not use unnecessary force; slamming the
Note
power supply into the chassis can damage the connectors on the rear of the power supply.
Seat the power supply in the SCE 2000 platform by tightening the captive installation screw with a
Step 4
1/4-inch flat-blade screwdriver.
The power supply is not fully seated until you tighten the installation screw on the faceplate.
Note
Reconnecting the Power
The following sections describe how to reconnect the AC or DC power:
•
•

How to Reconnect AC-Input Power Supply Unit

The following procedures explain how to reconnect an AC-input power to the SCE 2000 platform.
If you are reconnecting DC-input power, proceed to
SUMMARY STEPS
1.
2.
3.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
4-20
Grasp the power supply unit handle with one hand and place your other hand underneath the power
supply for support.
Fit the groove in the side of the new power supply module into the guide in the chassis.
Gently, but firmly, slide the module into the chassis until its faceplate is flush with the chassis rear
panel.
Seat the power supply in the SCE 2000 platform by tightening the captive installation screw with a
1/4-inch flat-blade screwdriver.
How to Reconnect AC-Input Power Supply Unit
How to Reconnect DC-Input Power Supply Unit
Plug the AC-input power cable into the AC-input power receptacle on the AC-input power supply
Plug the AC power supply cable into the AC power source.
Turn the on/off switch to the on (¿) position.
Chapter 4 Installation and Maintenance
How to Reconnect DC-Input Power Supply Unit.
OL-7824-06