Replacing The Power Supply Unit; Reconnecting The Power - Cisco SCE 1000 2xGBE Installation And Configuration Manual

Chapter 4 Installation and Maintenance

Replacing the Power Supply Unit

Do not mix AC-input and DC-input power supply units in the same SCE 1000 platform.
Warning
To install a new power supply into a SCE 1000 platform, complete the following steps:
Grasp the power supply unit handle with one hand and place your other hand underneath the
Step 1
power supply for support.
Fit the groove in the side of the new power supply module into the guide in the chassis.
Step 2
Step 3 Gently, but firmly, slide the module into the chassis until its faceplate is flush with the chassis rear
panel.
Warning When inserting a power supply into the SCE 1000 platform, do not use unnecessary force; slamming
the power supply into the chassis can damage the connectors on the rear of the power supply.
Seat the power supply in the SCE 1000 platform by tightening the captive installation screw with
Step 4
a 1/4-inch flat-blade screwdriver.
The power supply is not fully seated until you tighten the installation screw on the faceplate.
Note
This completes the procedures for replacing a power supply in a SCE 1000 platform.

Reconnecting the Power

The following sections describe how to reconnect the AC or DC power:
•
•
OL-7821-05
Reconnecting AC-Input Power Supply Unit (on page 4-18)
Reconnecting DC-Input Power Supply Unit (on page 4-18)
Removing and Replacing a Power Supply Unit
Cisco SCE 1000 2xGBE Installation and Configuration Guide
4-17