Rebooting And Shutting Down The Sce Platform; Rebooting The Sce Platform; Examples For Rebooting The Sce Platform; How To Shut Down The Sce Platform - Cisco SFE2000P Installation And Configuration Manual

Rebooting and Shutting Down the SCE Platform

Rebooting and Shutting Down the SCE Platform
•
•

Rebooting the SCE Platform

Rebooting the SCE platform is required after installing a new firmware, in order for that firmware to take
effect. There might be other occasions where rebooting the SCE platform is necessary.
Note When the SCE restarts, it loads the startup configuration, so all changes made in the running
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in
SUMMARY STEPS
1.
2.
DETAILED STEPS
At the SCE 2000# prompt, type reloadand press Enter.
Step 1
A confirmation message appears.
Type y to confirm the reboot request and press Enter.
Step 2

Examples for Rebooting the SCE Platform

The following example shows the commands for system reboot.
SCE 2000# reloadAre you sure? ythe system is about to reboot, this will end your CLI
session

How to Shut Down the SCE Platform

Shutting down the SCE platform is required before turning the power off. This helps to ensure that
non-volatile memory devices in the SCE platform are properly flushed in an orderly manner.
When the SCE platform restarts, it loads the startup configuration, so all changes made in the running
Note
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in
SUMMARY STEPS
1.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
7-10
Rebooting the SCE Platform
How to Shut Down the SCE Platform
How to Save or Change the Configuration
At the SCE 2000# prompt, type reloadand press Enter.
Type y to confirm the reboot request and press Enter.
How to Save or Change the Configuration
Connect to the serial console port (The CON connector on the SCE platform front panel, 9600 baud).
Chapter 7 Basic SCE 2000 Platform Operations
Settings.
Settings.
OL-7824-06