Information About The SCE Platform
Table 2-3
LED Groups
Bypass
GBE ports
Mng
Cisco SCE 2000 4xGBE Installation and Configuration Guide
2-4
SCE 2000 LED Groups
Chapter 2
Introduction to the SCE Platform
Description
Continuous green — indicates that the traffic
•
bypasses the SCE 2000 through an internal
electrical bypass module.
Single SCE 2000 topology — The SCE 2000
is either in bypass or sniffing mode
Cascaded topology — Either the SCE 2000 is
forwarding traffic to the other SCE 2000 ,
where it is being processed, or is simply in
bypass mode, so traffic through it is not being
processed.
•
Unlit — traffic is not being bypassed
Single SCE 2000 topology — indicates
normal operation of the SCE 2000
Cascaded topology — indicates normal
operation of the active SCE 2000
The GBE LEDs indicate the operational status of
the SCE 2000 line ports, as follows:
•
Link
Green — indicates that the port link is up
Unlit — indicates that the port link is down
Rx
•
Flashing Green — indicates that there are
incoming packets
Tx
•
Flashing Green — indicates that there are
outgoing packets
The Mng port LEDs indicate the operational status
of the SCE 2000 out-of-band LAN-based
management port, as follows:
Link/Active
•
Green — indicates that the port link is up
Unlit — indicates that the port link is down
•
10/100/1000
Steady green — indicates that the port is set to
100 Mbps
Unlit — indicates that the port is set to 10
Mbps
Orange — indicates that the port is set to 1000
Mbps
OL-7824-06