How To Load And Activate A Service Control Application - Cisco SFE2000P Installation And Configuration Manual

Chapter 6 Cabling the Line Ports and Completing the Installation
How to View the Current Connection Mode
Step 1 From the SCE 2000# prompt, type show interfacelinecard 0 connection-modeand press Enter.
How to View the Current Link Mode
From the SCE 2000# prompt, type show interface linecard 0 link modeand press Enter.
Step 1
How to View the Current Link Mappings
From the SCE 2000# prompt, type show interfacelinecard 0 physically-connected-linksand press
Step 1
Enter.

How to Load and Activate a Service Control Application

The SCE 2000 platform provides the basic functionalities of Service Control analysis and enforcement.
A Service Control solution requires that a Service Control application be loaded into the platform, to
take advantage of the unique SCE platform capabilities.
Loading and activating an application includes the following stages:
•
•
•
The detailed procedure of how to perform these operations is not specified and described in this manual.
For further details, refer to the following documentation:
•
•
OL-7824-06
Downloading the application provided as an SLI file to the SCE 2000 disk.
Activating the application.
Configuring the application.
Service Control Application for Broadband User Guide
Service Control Application for Broadband Reference Guide
How to Load and Activate a Service Control Application
Cisco SCE 2000 4xGBE Installation and Configuration Guide
6-15