Cisco SFE2000P Installation And Configuration Manual page 82

Initial System Configuration
The SNMP agent that resides inside the SCE 2000 will respond only to GET requests that use this
community string.
Enter SNMP GET community name:
Note that there is no default for this parameter.
Step 4 Assign an access list to restrict the SNMP management stations that may use this GET community.
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use '0' to allow all:
The maximum number of GET communities is 20.
Step 5
To add more entries, type yand press
•
• Enter
• Would you like to add another SNMP GET community? [no]: y
Enter up to 20 SNMP GET communities as described in and .
When all entries have been added, press
•
Enter
•
Would you like to add another SNMP GET community? [no]:
Step 6 Type the SNMP SET community name and press Enter.
The SNMP agent that resides inside the SCE 2000 will respond only to SET requests that use this
community string.
Enter SNMP SET community name:
Note that there is no default for this parameter.
Assign an access list to restrict the SNMP management stations that may use this SET community.
Step 7
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use '0' to allow all:
The maximum number of SET communities is 20.
Step 8
To add more entries, type yand press
•
Enter
•
Would you like to add another SNMP SET community? [no]:y
Enter up to 20 SNMP SET communities as described in and .
•
When all entries have been added, press
•
Enter
•
Would you like to add another SNMP SET community? [no]:
Enter the SNMP trap managers menu.
Step 9
Would you like to configure SNMP trap managers? [no]: y
Type yand press Enter.
The SNMP trap managers dialog begins.
If you choose not to configure SNMP trap managers, the dialog skips to the authentication failure trap
status. (See .)
Type the trap manager IP address and press Enter.
Step 10
Enter SNMP trap manager IP address:
Note that there is no default for this parameter.
Step 11 Type the trap manager community string and press Enter.
Note that there is no default for this parameter.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
5-18
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
OL-7824-06