Vrrp Priority - D-Link DXS-3600-16S Manual

vrrp vrid preempt
no vrrp vrid preempt
Parameters
vrid
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#vrrp 7 preempt
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#no vrrp 7 preempt
DXS-3600-32S(config-if)#

69-5 vrrp priority

This command is used to set the priority of a virtual router. Use the no form of this command to restore to the default
priority,
vrrp vrid priority priority
no vrrp vrid priority
Parameters
vrid
priority
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the virtual router identifier. The valid range is from 1 to 255.
By default, the preempt mode is enabled.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
In preempt mode, a router will take over the master role if it has a better priority than
the current master. To reduce unnecessary changes to the role in an unstable
network, the router will delay the process of taking over the master role for the
specified period of time. In non-preempt mode, the master will not be preempted
unless the incoming router is the IP address owner of the virtual router.
Use the command show vrrp to verify your settings.
This example shows how to configure the router for VRRP group 7 to preempt the
current master router.
This example shows how to configure the router to disable the preempt function of
the virtual router.
Specifies the virtual router identifier. The valid range is from 1 to 255.
Specifies the priority of the virtual router. A higher value means a higher priority. The
valid range is from 1 to 254.
The default value of priority of virtual router is 100.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
634