Distance Vector Multicast Routing Protocol (Dvmrp) Commands - D-Link DXS-3600-16S Manual

Distance Vector Multicast Routing Protocol (DVMRP)
Commands
15-1 ip dvmrp
This command is used to enable the Distance Vector Multicast Routing Protocol (DVMRP) on an interface. To disable
DVMRP on the interface, use the no form of this command.
ip dvmrp
no ip dvmrp
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip dvmrp
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#no ip dvmrp
DXS-3600-32S(config-if)#
15-2 ip dvmrp metric
This command is used to configure the metric value on the current interface. To restore the default value, use no form
of this command.
ip dvmrp metric METRIC
no ip dvmrp metric
Parameters
METRIC
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
By default, this option is disabled.
Interface Configuration Mode
Level: 8. (EI Mode Only Command)
This command enables DVMRP on the specified interface.
If you want to use DVMRP to forward multicast packets, use the ip multicast-
routing command to enable the multicast global state.
To verify you configuration, use the show ip dvmrp interface command.
This example shows how to enable DVMRP on interface VLAN 1.
This example shows how to disable DVMRP on interface VLAN 1.
Specifies the metric value of the interface. The range is 1 to 31.
The default value is 1.
Interface Configuration Mode
Level: 8. (EI Mode Only Command)
220