Port Commands - D-Link DXS-3600-16S Manual

Port Commands

43-1 interface
This command is used to enter the interface configure mode.
interface {tenGigabitEthernet <port>}
interface range {tenGigabitEthernet <portlist>}
Parameters
tenGigabitEthernet <port> Specifies that the Ten Gigabit Ethernet is the port type which want to configure, the
tenGigabitEthernet
<portlist>
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#exit
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/10
DXS-3600-32S(config-if-range)#
43-2 medium-type
This command is used to specify the medium type while the configure ports are combo ports.
medium-type {copper | fiber}
no medium-type
Parameters
copper
fiber
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
<port> is define the ports which want to configure
Specifies that the Ten Gigabit Ethernet is the port type which want to configure, the
<portlist> is define the ports which want to configure
None.
Global Configuration Mode.
Level: 15
To configure the attribute of the port-interface, use this command the enter port
configure mode.
This example shows how to configure the attributes of the port-interface.
Specifies that the copper port will be configured.
Specifies that the fiber port will be configured.
None.
Port Configuration Mode.
Level: 15
To configure the attributes of the port-interface for a specified type of combo port.
Use this command to change the medium type to the specified medium type.
421