Show Ip Bgp Dampening Parameters - D-Link DXS-3600-16S Manual

7-78 show ip bgp dampening parameters

This command is used to display the BGP dampening configuration.
show ip bgp dampening parameters [vrf VRF-NAME]
Parameters
vrf VRF-NAME
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show ip bgp dampening parameters
BGP Dampening Parameter for IPv4 Unicast
------------------------------------------
BGP Dampening State
BGP Dampening Route Map
Half-life Time
Reuse Value
Suppress Value
MAX Suppress Time
Unreachable route's Half-life
DXS-3600-32S#
Example
DXS-3600-32S#show ip bgp dampening parameters vrf VPN-A
BGP Dampening for vrf
---------------------------------------------------------
BGP Dampening State
BGP Dampening Route Map
Half-life Time
Reuse Value
Suppress Value
MAX Suppress Time
Unreachable route's Half-life
DXS-3600-32S#
Display Parameters
BGP Dampening State
BGP Dampening Route Map
Half-Life Time
Reuse Value
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
(Optional) Specifies the VRF name. The length of the VRF-NAME is 12 characters.
None.
Privileged Mode.
Level: 3. (EI Mode Only Command)
Use this command to display the dampening parameters of BGP.
This example shows how to display the dampening configuration information by
using the show ip bgp dampening parameters command, in privileged mode.
: Disabled
:
: 15 mins
: 750
: 2000
: 60 mins
: 15 mins
The following example is to show the dampening configuration information by using
the show ip bgp dampening parameters vrf command in privileged mode.
: VPN-A
: Disabled
:
: 15 mins
: 750
: 2000
: 60 mins
: 15 mins
Description
Specifies the BGP dampening function's state.
The route map here is to set the dampening.
Specifies the time (in minute) after which the penalty of the reachable routes will be
down, by half. The default setting is 15 minutes.
If the penalty for a flapping route decreases enough to fall below this value, the route
is unsuppressed. The default setting is 750
133