Compound Authentication Commands - D-Link DXS-3600-16S Manual

Compound Authentication Commands

8-1 network-access guest-vlan
This command is used to specify an active VLAN as a guest VLAN for network-access authentication module. Use the
no form of this command to return to the default setting.
network-access guest-vlan VLAN-ID
no network-access guest-vlan
Parameters
VLAN-ID
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#network-access guest-vlan 5
DXS-3600-32S(config-if)#
8-2 show network-access guest-vlan
This command is used to display the guest VLAN configuration.
show network-access guest-vlan
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies an active VLAN as a guest VLAN. The range is 1 to 4094.
No guest VLAN is configured.
Interface Configuration Mode.
Level: 8
You can configure a guest VLAN on one of these switch ports:
• A static-access port that belongs to a non-private VLAN.
• When configure authentication VLAN under host-base mode to a port, it cannot
be a guest VLAN port.
• A guest VLAN port cannot be a IGMP multicast VLAN port.
For each network-access port on the switch, you can configure a guest VLAN to
provide limited services to un-authenticated clients.
This example shows how to specify VLAN 5 as a guest VLAN.
None.
None.
Privileged EXEC Mode.
Level: 3
This command is used to display the guest VLAN configuration.
172