Show Ip Pim - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#show ip pim sparse-mode rp-hash 229.1.3.1
RP: 10.2.0.2, via bootstrap
Uptime 00:36:46, expires in 00:01:44
DXS-3600-32S#
Example
DXS-3600-32S#show ip pim sparse-mode rp-hash 239.0.0.0
RP: 10.90.90.90, static
DXS-3600-32S#
Display Parameters
static
RP

47-19 show ip pim

This command is used to display PIM global information.
show ip pim
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show ip pim
Register Suppression Time
Register Keepalive Time
C-RP Wildcard Prefix Count
SPT Threshold
RP Address
1.1.1.1, group-list: static-rp-acl
RP Candidate
vlan1, group-list: candidate-rp
vlan2, group-list: crp-system
SSM Group : ssm-acl
Old Register Checksum to RP Address
-----------------------------------
172.18.1.2
DXS-3600-32S#
Display Parameters
Register Keepalive Time
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows PIM-SM RP information for 229.1.3.1.
This example shows PIM-SM RP information for 239.0.0.0.
Description
Group-to-mapping information from the static rendezvous-point configuration.
Address of the rendezvous point for that group.
None.
None.
Privileged EXEC Mode.
Level: 3. (EI Mode Only Command)
Use this command to display global information of PIM.
This example shows global information of PIM.
: 100
: 185
: 1
: 0
Description
Value in seconds. To configure this value, use command ip pim rp-register-kat.
464