Simple Network Management Protocol (Snmp) Commands - D-Link DXS-3600-16S Manual

Simple Network Management Protocol (SNMP)
Commands
55-1 snmp-server
This command is used to enable the Simple Network Management Protocol (SNMP) agent. To stop and shield the
SNMP agent, use the no form of this command.
snmp-server
no snmp-server
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#snmp-server
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no snmp-server
DXS-3600-32S(config)#
55-2 no enable service snmp-agent
This command is used to disable the SNMP Agent.
no enable service snmp-agent
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no enable service snmp-agent
DXS-3600-32S(config)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
SNMP global state is disabled.
Global Configuration Mode.
Level: 12
The remote SNMP manager sends SNMP requests to agents and receives SNMP
responses and notifications from agents. When the SNMP agent is enabled, the
remote SNMP manager can query SNMP agents and send SNMP traps. This
command will shield the SNMP agent service and related configuration by executing
the no snmp-server command.
This example shows how to enable the SNMP global setting.
This example shows how to disable the SNMP global setting.
None.
None.
Global Configuration Mode.
Level: 12
This command will act on all of the SNMP services instead of shielding the
configuration information of the SNMP Agent.
This example shows how to disable the SNMP global setting.
539