Link Aggregation Commands - D-Link DXS-3600-16S Manual

Link Aggregation Commands

31-1 aggregateport load-balance
This command is used to specify the load-balance algorithm. Use the no command to return it to the default setting.
aggregateport load-balance {dst-mac | src-mac | src-dst-mac | dst-ip | src-ip | src-dst-ip}
no aggregateport load-balance
Parameters
dst-mac
src-mac
src-dst-mac
dst-ip
src-ip
src-dst-ip
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#aggregateport load-balance src-mac
DXS-3600-32S(config)#
31-2 lacp port-priority
This command is used to set the LACP port priority. Use the no form of this command to return to the default value.
lacp port-priority port-priority
no lacp port-priority
Parameters
port-priority
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies that the switch should examine the MAC destination address.
Specifies that the switch should examine the MAC source address.
Specifies that the switch should examine the MAC source and destination address.
Specifies that the switch should examine the IP destination address.
Specifies that the switch should examine the IP source address.
Specifies that the switch should examine the IP source and destination address.
Traffic is distributed according to the destination and source MAC addresses of the
packets.
Global Configuration Mode.
Level: 15
None.
This example shows how to configure global load balance.
Specifies the port priority, in the range of 0-65535.
By default, the port priority is 32768.
Interface Configuration Mode.
Level: 15
The LACP port-priority interface configuration command determines which ports are
bundled.
In port-priority comparisons, a numerically lower value has a higher priority. If two or
more ports have the same LACP port priority (for example, they are configured with
the default setting of 32768), lower port number has higher priority.
303