Figure 3-45 Spot Monitor Screen - Honeywell HRXDS16D1T User Manual

Configuration
5.
6.
7.
Spot Monitor
1.
2.
3.
Document 800-04559 Rev D
11/09
You can define the screen layout in a variety of formats and set the DVR to
sequence through the different screen layouts (pages) so that all the cameras will
be displayed. You can also set up the DVR to display one camera or a group of
cameras all the time while cycling through the remaining cameras in a cameo
window. This can be done with one camera displayed full screen while displaying
the cameo window as a PIP (picture in picture), or displaying the cameras in a grid
pattern with the bottom right window as the cameo.
Note Sequence cannot be used in the 4x4 display mode of the
16-channel, and 3x3 mode of the 8-channel DVR.
To adjust the display dwell time, highlight the box beside Interval, then press #.
You can select dwell intervals ranging from 1 second to 1 minute.
Highlight Event Monitoring On, then press #. Press # to toggle between On and
Off. When it is On, the DVR displays the camera associated with the event when
an event occurs.
On the Display screen (see
to the Spot Monitor screen.
Figure 3-45
You can define which cameras display sequentially on the Spot Monitors.
Highlight the box in the Channels column for the desired Spot Monitor, then
press #.
To save your Display settings, highlight Save, then press #.
Select Cancel to exit the screen without saving the changes.
Figure 3-42), highlight the Spot Monitor tab to switch
Spot Monitor Screen
75