Spot Monitoring Setup Screen; Figure 3-42 Spot Monitoring Setup Screen - Honeywell HRHD4+ User Manual

Configuration
camera displayed full screen while displaying the cameo window as a PIP
(picture-in-picture), or displaying the cameras in a grid pattern with the bottom right
window as the cameo.
3.
4.

Spot Monitoring Setup Screen

Use this screen (MENU
time for each camera displayed on the spot monitor. You can also turn event monitoring
on and off.
1.
2.
3.
Rev 3.01
Note Sequence cannot be used in the 4x4 display mode of the
16-channel, 3x3 mode of the 9-channel, or the 2x2 mode of the
4-channel DVR.
Highlight the box beside Event Monitoring and then press # to toggle between
On and Off. When it is On, the video of the lowest camera number among
cameras associated with the event-detected sensor will be displayed in full-screen
on the main monitor during the preset dwell time.
Highlight the box beside Event Monitoring Dwell Time and then press # . You
can adjust the event monitoring dwell time from 3 to 60 seconds.
Figure 3-42
Highlight the box beside Sequence Dwell Time and then press # . You can adjust
the sequence dwell time from 3 to 60 seconds.
Highlight the box beside Event Monitoring and then press # to toggle between
On and Off. When it is On, the video of the lowest camera number among
cameras associated with the event-detected sensor will be displayed in full-screen
on the spot monitor during the preset dwell time.
Highlight the box beside Event Monitoring Dwell Time and then press # . You
can adjust the event monitoring dwell time from 3 to 60 seconds.
Display Spot Monitoring) to adjust the display dwell
Spot Monitoring Setup Screen
60 Document 900.0258
10/05