Honeywell HRXDS16D1T User Manual page 132

4.
5.
Caution
132
Highlight Start, then press # to display a confirmation screen asking you to
confirm whether or not you want to start mirroring the selected disk. After you start
mirroring, the two disks will be resynchronized. Any data on the destination disk
will be erased, and the data on the source disk will be copied to the destination
disk. If the source disk is formatted and has no data, the disks will not be
resynchronized. Resynchronization takes about 40 minutes per each 10 GB of
capacity. After resynchronization is complete, disk mirroring (writing data on the
two disks at the same time) will start.
Note Resynchronization will pause while searching video.
After disk mirroring starts, you can cancel it by highlighting Stop, then press #.
Select Stop to display a confirmation screen asking you to confirm whether or not
you want to stop mirroring for the selected disk.
Note After disk mirroring stopped, the destination disk will be set to
Not Used. If resynchronization has been finished, the destination
disk cannot be used for recording or archiving, but it can be
used for searching. If you want to use the disk for recording or
archiving, you must reformat it.
Disk mirroring will NOT automatically restart from an interrupted
state. After mirroring is stopped, you must restart it by following
the mirroring setup procedures.
HRXDS Series DVR User Guide