Cisco CP-7911G-CH1 System Administrator Manual page 99

Setting Up Cisco Unified IP Phones using SCCP
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Step 4
max-dn max-no-of-directories [dual-line |
octo-line] [number octo-line]
Example:
Router(config-cm-fallback)# max-dn 15 dual-line
6 octo-line
Step 5
huntstop channel 1-8
Example:
Router(config-cm-fallback)# huntstop channel 4
Step 6
end
Example:
Router(config)# end
OL-13143-04
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Enters call-manager-fallback configuration mode.
Sets the maximum number of DNs or virtual voice ports
that can be supported by the router and activates dual-line
mode, octo-line mode, or both modes.
max-no-of-directories: Maximum number of directory
•
numbers (dns) or virtual voice ports supported by the
router. The maximum number is platform-dependent.
The default is 0.
dual-line: (Optional) Allows IP phones in
•
Cisco Unified Communications Manager fallback
mode to have a virtual voice port with two channels.
octo-line: (Optional) Allows IP phones in
•
Cisco Unified Communications Manager fallback
mode to have a virtual voice port with eight channels.
number (Optional): Sets the number of directory
•
numbers for octo-mode.
Enables channel huntstop on an octo-line, which keeps a
call from hunting to the next channel of a directory number
if the last allowed channel is busy or does not answer.
• number: Number of channels available to accept
incoming calls. The remaining channels are reserved
for outgoing calls and features such as call transfer,
call waiting, and conferencing. The range is 1 to 8 and
the default is 8.
The command is supported for octo-line directory
•
numbers only.
Returns to privileged EXEC mode.
Cisco Unified SCCP and SIP SRST System Administrator Guide
How to Set Up Cisco Unified IP Phones
99