Cisco CP-7911G-CH1 System Administrator Manual page 308

How to Use Cisco Unified SRST Gateways as a Multicast MOH Resource
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
DETAILED STEPS
Command or Action
Step 1
voice-port port
Example:
Router(config)# voice-port 1/1/0
Step 2
input gain decibels
Example:
Router(config-voice-port)# input gain 0
Step 3
auto-cut-through
Example:
Router(config-voiceport)# auto-cut-through
Step 4
operation 4-wire
Example:
Router(config-voiceport)# operation 4-wire
Step 5
signal immediate
Example:
Router(config-voiceport)# signal immediate
Step 6
no shutdown
Example:
Router(config-voiceport)# no shutdown
Step 7
exit
Example:
Router(config-voiceport)# exit
Cisco Unified SCCP and SIP SRST System Administrator Guide
308
Appendix B: Integrating Cisco Unified Communications Manager and Cisco Unified SRST to Use Cisco Unified SRST
voice-port port
input gain decibels
auto-cut-through (E&M only)
operation 4-wire (E&M only)
signal immediate (E&M only)
no shutdown
exit
Purpose
Enters voice-port configuration mode to set up the physical
voice port. To find the correct definition of the port
argument for your router, see
Site Telephony Version 3.2 Command
Specifies, in decibels, the amount of gain to be inserted at
the receiver side of the interface. Acceptable values are
integers from –6 to 14.
(E&M ports only) Enables call completion when a PBX
does not provide an M-lead response. MOH requires that
you use this command with E&M ports.
(E&M ports only) Selects the 4-wire cabling scheme. MOH
requires that you specify 4-wire operation with this
command for E&M ports.
(E&M ports only) For E&M tie trunk interfaces, directs the
calling side to seize a line by going off-hook on its E-lead
and to send address information as DTMF digits.
Activates the voice port.
Exits voice-port configuration mode.
Cisco IOS Survivable Remote
Reference.
OL-13143-04