Where To Go Next - Cisco CP-7911G-CH1 System Administrator Manual

Cisco Unified SIP SRST 4.1
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
voice register global
Example:
Router(config)# voice register global
Step 4
system message string
Example:
Router(config-register-global)# system message
fallback active
Step 5
end
Example:
Router(config-register-global)# end
Step 6
show voice register global
Example:
Router# show voice register global

Where to Go Next

The next step is configuring Cisco Unified IP phones using SCCP. For instructions, see the
Cisco Unified IP Phones using SCCP" section on page
For additional information, see the
SCCP and SIP SRST Feature Overview"
OL-13143-04
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Enters voice register global configuration mode to set
global parameters for all supported SIP phones in a
Cisco Unified CME environment.
Defines a status message that displays on SIP phones
registered to Cisco Unified SRST.
string: Up to 32 alphanumeric characters. Default is
•
"CM Fallback Service Operating."
Exits to privileged EXEC mode.
Displays all global configuration parameters associated
with SIP phones.
85.
"Additional References" section on page 26
chapter.
Cisco Unified SCCP and SIP SRST System Administrator Guide
Where to Go Next
"Setting Up
in the "Cisco Unified
83