How To Set Up Cisco Unified Ip Phones; Configuring Cisco Unified Srst To Support Phone Functions - Cisco CP-7911G-CH1 System Administrator Manual

How to Set Up Cisco Unified IP Phones

How to Set Up Cisco Unified IP Phones
This section contains the following tasks:
•
•
•
•
•
•
•
•
•
•
•

Configuring Cisco Unified SRST to Support Phone Functions

Tip When the Cisco Unified SRST is enabled, Cisco Unified IP Phones do not have to be reconfigured while
in Cisco Unified Communications Manager fallback mode because phones retain the same configuration
that was used with Cisco Unified Communications Manager.
To configure Cisco Unified SRST on the router to support the Cisco Unified IP Phone functions, use the
following commands beginning in global configuration mode.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
Cisco Unified SCCP and SIP SRST System Administrator Guide
86
Configuring Cisco Unified SRST to Support Phone Functions, page 86
Configuring Cisco Unified 8941 and 8945 SCCP IP Phones, page 88
Verifying That Cisco Unified SRST Is Enabled, page 89
Configuring IP Phone Clock, Date, and Time Formats, page 90
Configuring IP Phone Language Display, page 92
Configuring Customized System Messages for Cisco Unified IP Phones, page 94
Configuring a Secondary Dial Tone, page 95
Configuring Dual-Line Phones, page 96
Configuring Eight Calls per Button (Octo-Line), page 98
Configuring the Maximum Number of Calls, page 100
Troubleshooting, page 102
call-manager-fallback
ip source-address ip-address [port port] [any-match | strict-match]
max-dn max-directory-numbers [dual-line] [preference preference-order]
max-ephones max-phones
limit-dn phone-type max-lines
exit
(Optional)
(Optional)
(Required Under Certain Conditions)
(Optional)
Setting Up Cisco Unified IP Phones using SCCP
(Required)
(Required)
(Optional)
(Optional)
(Optional)
(Optional)
(Optional)
OL-13143-04