Cisco CP-7911G-CH1 System Administrator Manual page 141

Configuring Call Handling
In the configuration below, the voice translation-rule and the rule command allow you to set and define
how a number is to be manipulated. The translate command in voice translation-profile mode defines
the type of number you are going to manipulate, such as a called, calling, or a redirecting number. Once
you have defined your translation profiles, you can then apply the translation profiles in various places,
such as dial peers and voice ports. For SRST, you apply your profiles in call-manager fallback mode.
Cisco IP phones support one incoming and one outgoing translation profile when in SRST mode.
For Cisco SRST 3.2 and later versions and Cisco Unified SRST 4.0 and later versions, use the voice
Note
translation-rule and translation-profile commands shown below instead of the translation rule
configuration described in the
rules are a separate feature from translation rules. See the
Voice Command Reference
Routing Enhancements
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
OL-13143-04
"Enabling Digit Translation Rules" section on page
for more information and the
documentation for more general information on translation rules and profiles.
voice translation-rule number
rule precedence/match-pattern/ /replace-pattern/
exit
voice translation-profile name
translate {called | calling | redirect-called} voice-translation-rule-tag
exit
call-manager-fallback
translation-profile {incoming | outgoing} name
exit
How to Configure Cisco Unified SCCP SRST
voice translation-rule
VoIP Gateway Trunk and Carrier Based
Cisco Unified SCCP and SIP SRST System Administrator Guide
139. Voice translation
command in Cisco IOS
141