Cisco CP-7911G-CH1 System Administrator Manual page 239

Integrating Voice Mail with Cisco Unified SRST
Command or Action
Step 4
forward-digits {num-digit | all | extra}
Example:
Router(config-dial-peer)# forward-digits all
Step 5
exit
Example:
Router(config-dial-peer)# exit
Table 1 Valid Entries for the String Argument in the destination-pattern command
Entry
Digits 0 to 9
Letters A through D
Asterisk (*) and pound sign (#)
Comma (,)
Period (.)
Percent sign (%)
Plus sign (+)
Circumflex (^)
Dollar sign ($)
Backslash symbol (\)
Question mark (?)
Brackets ( [ ] )
OL-13143-04
Purpose
(Optional for FXO or FXS) Specifies which digits to forward
for voice calls.
(FXO or FXS and BRI or PRI) Exits dial-peer configuration
mode.
Description
—
—
These appear on standard touch-tone dial pads.
Inserts a pause between digits.
Matches any entered digit (this character is used as a wildcard).
Indicates that the preceding digit occurred zero or more times; similar to the wildcard
usage.
Indicates that the preceding digit occurred one or more times.
Note The plus sign used as part of a digit string is different from the plus sign that
can be used in front of a digit string to indicate that the string is an E.164
standard number.
Indicates a match to the beginning of the string.
Parentheses ( ( ) ), which indicate a pattern and are the same as the regular expression
rule.
Matches the null string at the end of the input string.
Is followed by a single character and matches that character. Can be used with a single
character with no other significance (matching that character).
Indicates that the preceding digit occurred zero or one time.
Indicates a range. A range is a sequence of characters enclosed in the brackets; only
numeric characters from 0 to 9 are allowed in the range.
Cisco Unified SCCP and SIP SRST System Administrator Guide
How to Integrate Voice Mail with Cisco Unified SCCP and SIP SRST
• num-digit: The number of digits to be forwarded. If the
number of digits is greater than the length of a destination
phone number, the length of the destination number is used.
Range is 0 to 32. Setting the value to 0 is equivalent to
entering the no forward-digits command.
all: Forwards all digits. If all is entered, the full length of
•
the destination pattern is used.
extra: If the length of the dialed digit string is greater than
•
the length of the dial-peer destination pattern, the extra
right-justified digits are forwarded. However, if the
dial-peer destination pattern is variable length and ends
with the character "T" (for example: T, 123T, 123...T),
extra digits are not forwarded.
239