Cisco CP-7911G-CH1 System Administrator Manual page 146

How to Configure Cisco Unified SCCP SRST
DETAILED STEPS
Command or Action
Step 1
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Step 2
timeouts busy seconds
Example:
Router(config-cm-fallback)# timeouts busy 20
Step 3
exit
Example:
Router(config-cm-fallback)# exit
Examples
The following example sets a timeout of 20 seconds for calls that are transferred to busy destinations:
call-manager-fallback
timeouts busy 20
Configuring the Ringing Timeout Default
The ringing timeout default is the length of time for which a phone can ring with no answer before
returning a disconnect code to the caller. This timeout prevents hung calls received over interfaces such
as Foreign Exchange Office (FXO) that do not have forward-disconnect supervision. It is used only for
extensions that do not have no-answer call forwarding enabled.
SUMMARY STEPS
1.
2.
3.
Cisco Unified SCCP and SIP SRST System Administrator Guide
146
call-manager-fallback
timeouts ringing seconds
exit
Purpose
Enters call-manager-fallback configuration mode.
Sets the amount of time after which calls are disconnected
when they are transferred to busy destinations.
seconds: Number of seconds. Range is from 0 to 30.
•
Default is 10.
This command sets the busy timeout only for calls
Note
that are transferred to busy destinations and does
not affect the timeout for calls that directly dial
busy destinations.
Exits call-manager-fallback configuration mode.
Configuring Call Handling
OL-13143-04