Table of Contents
Advertisement
How to Configure Cisco Unified SIP SRST 4.1 Features
Command or Action
Step 4
no supplementary-service sip {moved-temporarily
| refer}
Example:
Router(conf-voi-serv)# no supplementary-service
sip refer
or
Router(config-dial-peer)# no
supplementary-service sip refer
Step 5
end
Example:
Router(config-voi-serv)# end
or
Router(config-dial-peer)# end
Configuring Idle Prompt Status for SIP Phones
Perform the following steps to customize the message that displays on SIP phones after the phones
failover to Cisco Unified SRST.
You do not need to create new configuration files with the create profile command and restart the phones
Note
after changing the idle status message in Cisco Unified SRST. Modifying the status message takes effect
immediately in Cisco Unified SRST.
Prerequisites
Cisco Unified SRST 4.1 or a later version.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
Cisco Unified SCCP and SIP SRST System Administrator Guide
82
enable
configure terminal
voice register global
system message string
end
show voice register global
Purpose
Disables SIP call forwarding or call transfer supplementary
services globally or for a dial peer.
•
moved-temporarily: SIP redirect response for call
forwarding.
refer: SIP REFER message for call transfers.
•
•
Sending REFER and redirect messages to the
destination is the default behavior.
This command is supported for calls between SIP
Note
phones and calls between SCCP phones. It is not
supported for a mixture of SCCP and SIP endpoints.
Exits to privileged EXEC mode.
Cisco Unified SIP SRST 4.1
OL-13143-04
Advertisement
Table of Contents
Troubleshooting
