Chapter 2 Using The Setup Command Facility; Before Powering On Your Cisco Iad - Cisco 2431 - IAD Router Software Configuration Manual

Using the setup Command Facility
This chapter describes how to use the setup command facility to configure your Cisco integrated access
device (IAD). The setup command facility prompts you to enter information needed to start a router
functioning quickly. The facility steps you through a basic configuration, including LAN and WAN
interfaces.
This chapter presents the following major topics:
•
•
•
•
•
If you prefer to configure the router manually or if you wish to configure a module or interface that is
not included in the setup command facility, proceed to
Command-Line Interface,"
If you prefer to configure the router by using AutoInstall, see the
Configure Cisco Networking Devices

Before Powering On Your Cisco IAD

Before you power on your Cisco IAD and begin to use the setup command facility, follow these steps:
Step 1 Set up the hardware as described in the hardware installation documents for your Cisco IAD.
Step 2 Configure your PC terminal emulation program for 9600 baud, 8 data bits, no parity, and 1 stop bit.
Determine which network protocols you are supporting.
Step 3
Determine the following for each network protocol:
Step 4
•
•
OL-4306-03
Before Powering On Your Cisco IAD, page 2-1
The setup Command Facility, page 2-2
Configuring Global Parameters, page 2-2
Configuring Controller and Interface Parameters, page 2-5
Completing the Configuration, page 2-13
for step-by-step instructions.
Addressing plan
Which WAN protocols you will run on each interface (for example, Frame Relay [FR], High-Level
Data Link Control [HDLC], X.25, and so on)
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
C H A P T E R
"Chapter 3, "Configuring with the
document.
2
Using AutoInstall to Remotely
2-1