Configuring T1/E1 Interfaces
Configuring Channel Groups on T1/E1 to Support Data
To support data, use the following procedure to configure a new T1/E1 interface for channelized T1/E1
(CT1) or PRI, or to change the configuration of an existing interface.
To configure channel groups on T1/E1 to support data, perform the following steps.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router# enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
ip routing
Example:
Router(config)# ip routing
Step 4
controller t1 slot/port
Example:
Router(config)# controller t1 0/2
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
3-8
enable
configure terminal
ip routing
controller t1 slot/port
clock source line
framing t1/e1 controller
framing t1/e1 controller
linecode {ami|b8zs|hdb3}
linecode {ami|b8zs|hdb3}
channel-group channel-group-number timeslots range
interface type number
ip address ip address subnet mask
exit
Ctrl-z
Chapter 3
Configuring with the Command-Line Interface
Purpose
Enters privileged EXEC mode.
Enters global configuration mode.
Enables routing protocols as required for your global
configuration. This example uses IP routing.
Selects the CT1, CE1, PRI interface to configure.
Controller numbers vary. See the
Conventions" section on page
"Port Numbering
1-5.
OL-4306-03