Configuring Atm T1-Wan Ports - Cisco 2431 - IAD Router Software Configuration Manual

Configuring ATM T1-WAN Ports

Command or Action
Step 6
cptone local
Example:
Router(config-voice-port)# cptone ca
Step 7
description string
Example:
Router(config-voice-port)#
description purchasing_dept
Step 8
exit
Example:
Router(config-voice-port)# exit
Step 9
Ctrl-z
Example:
Router#

Configuring ATM T1-WAN Ports

If your Cisco IAD has a T1-WAN port, a default ATM configuration is automatically enabled when you
enter the mode atm controller command.
The Cisco IAD2435 router does not support an ATM interface.
Note
The default ATM configuration has the following operating parameters:
•
•
•
•
•
To configure the ATM interface parameters for your application, you need the following information:
•
•
•
Perform the following steps to enter an ATM configuration.
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
3-28
Maximum virtual path identifiers (VPIs) per virtual channel identifier (VCI) (atm
vc-per-vc)—1024.
No IP address.
ATM User to Network Interface (UNI) Version 3.0 is assigned.
ATM Integrated Local Management Interface (ILMI) keepalive is disabled.
No ATM PVCs are configured.
IP addresses and subnet masks
VPI/VCI numbers
Any other information related to the routing protocol
Chapter 3 Configuring with the Command-Line Interface
Purpose
Configures the appropriate call progress tone for the
local region.
The default for this command is northamerica. For a list
of supported countries, see the Cisco Voice, Video, and
Fax Command Reference, Release 12.3(4)T.
(Optional) Enters a string description for the voice port.
The string describes the voice port in displays. You can
use the description command to note the voice port
location or use.
Exits to voice-port mode.
Returns to enable mode when you finish configuring the
interfaces.
OL-4306-03