Lapb Encapsulation; Smds Encapsulation - Cisco 2431 - IAD Router Software Configuration Manual

Configuring Controller and Interface Parameters
Sample configurations for the following encapsulation types are provided in this section:
•
•
•
•
Frame Relay Encapsulation
The following is an example of a typical Frame Relay encapsulation configuration:
The following lmi-types are available to be set,
when connected to a frame relay switch
Enter lmi-type [2]:
The setup command facility prompts for the data-link connection identifier (DLCI) number only if you
Note
specify none for the Local Management Interface (LMI) type. If you accept the default or specify
another LMI type, the DLCI number is provided by the specified protocol.
Enter the DLCI number for this interface [16]:
Do you want to map a remote machine's IP address to dlci? [yes]:
IP address for the remote interface: 2.0.0.2
Do you want to map a remote machine's IPX address to dlci? [yes]:
IPX address for the remote interface: 40.1234.5678
Serial interface needs clock rate to be set in dce mode.
The following clock rates are supported on the serial interface.
choose speed from above: [2000000]: 1200
Configure IP on this interface? [yes]:
IP address for this interface: 2.0.0.1
Subnet mask for this interface [255.0.0.0]:
Class A network is 2.0.0.0, 8 subnet bits; mask is /8

LAPB Encapsulation

The following is an example of a typical LAPB configuration:
lapb circuit can be either in dce/dte mode.
Choose either from (dce/dte) [dte]:
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
2-8
Frame Relay Encapsulation
LAPB Encapsulation
X.25 Encapsulation

SMDS Encapsulation

[0] none
[1] ansi
[2] cisco
[3] q933a
0
1200, 2400, 4800, 9600, 19200, 38400
56000, 64000, 72000, 125000, 148000, 500000
800000, 1000000, 1300000, 2000000, 4000000, 8000000
Chapter 2 Using the setup Command Facility
OL-4306-03