Cisco 2431 - IAD Router Software Configuration Manual page 67

Chapter 3 Configuring with the Command-Line Interface
6.
7.
8.
9.
10.
11.
12.
13.
14.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router# enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface atm slot/port
Example:
Router(config)# interface atm 1/0
Step 4
ip address ip address subnet mask
Example:
Router(config-if)# ip address 172.16.74.3
255.255.255.0
Step 5
pvc name vpi/vci
Example:
Router(config-if)# pvc cisco 0/8
Step 6
protocol ipv6 ipv6-address
Example:
Router(config-if-vc)# protocol ipv6 address
2001:0DB8:2222::72/32
OL-4306-03
protocol ipv6 ipv6-address
vbr-rt peak-rate average-rate burst
encapsulation {aal5ciscoppp|aal5mux|aal5nlpid|aal5snap}
exit
dsl operating-mode
no shutdown
exit
exit
show interface atm slot/port
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
Configuring 1-Port ADSL/SHDSL WAN Interface Card
Purpose
Enters privileged EXEC mode.
Enters global configuration mode.
Enters ATM configuration mode for the ATM interface
in the specified slot and port.
Assigns an IP address to the ADSL/SHDSL ATM
interface.
Enters atm-virtual-circuit (interface-atm-vc)
configuration mode, and configure a new ATM PVC by
assigning a name (optional) and VPI/VCI numbers.
The default traffic shaping is unspecified bit rate (UBR);
the default encapsulation is ATM adaption layer 5+
(AAL5+), Logical Link Control Protocol (LLC),
Subnetwork Access Protocol (SNAP).
(Optional) Enables IP connectivity and creates a
point-to-point IP address for the VC.
3-33