Cisco 2431 - IAD Router Software Configuration Manual page 46

Configuring T1/E1 Interfaces
Configuring Switch Types for ISDN PRI Q.931 Support
Perform the following steps to configure Q Signalling (QSIG) signaling support on Cisco IAD2430
series IADs.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router# enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
isdn switch-type primary
Example:
Router(config)# isdn switch-type primary-net5
Step 4
controller t1/e1 slot/port
Example:
Router(config)# controller t1 0/2
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
3-12
enable
configure terminal
isdn switch-type primary
controller t1/e1 slot/port
pri-group timeslots range
isdn protocol-emulate {user|network}
no line-power
isdn incoming-voice voice
exit
Ctrl-z
Chapter 3 Configuring with the Command-Line Interface
Purpose
Enters privileged EXEC mode.
Enters global configuration mode.
(Optional; see note.) Selects a service provider switch
type that accommodates PRI.
You can configure the ISDN switch type in either
Note
global or interface configuration mode.
If you configure the switch type here, specify the switch
type for all PRI ports.
If you configure the switch type on a single interface,
specify the switch type for that interface. The switch type
specified for any individual interface overrides the
globally specified switch type.
Enters controller configuration mode for the controller at
the specified slot/port location. Valid values for slot and
port are 0 and 1.
OL-4306-03