Cisco 2431 - IAD Router Software Configuration Manual page 24

Configuring Global Parameters
When the following message appears, enter yes to begin the initial configuration dialog:
Step 2
Would you like to enter the initial configuration dialog? [yes/no]:
Note
Note
When the following message appears, press Enter to see the current interface summary:
Step 3
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
FastEthernet0/0
FastEthernet0/1
Enter a hostname for the Cisco IAD:
Step 4
Configuring global parameters:
Enter hostname [Router]: IAD2435
The enable secret is a password used to protect access to privileged EXEC and
configuration modes. This password, after entered, becomes encrypted in the configuration.
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
Step 5
viewing the configuration:
Enter enable secret: xxxx
The enable password is used when you do not specify an enable secret password, with some
older software versions, and some boot images.
Step 6 Enter an enable password that is different from the enable secret password. This password is not
encrypted (less secure) and can be seen when viewing the configuration:
Enter enable password: guessme
The virtual terminal password is used to protect access to the router over a network
interface.
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports
Step 7
other than the console port:
Enter virtual terminal password: guessagain
Respond to the following prompts as appropriate for your network:
Step 8
Configure SNMP Network Management? [yes]: n
Configure bridging? [no]:
Configure IP? [yes]:
Configure RIP routing? [yes]: n
Configure CLNS? [no]:
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
2-4
If you answer no to this message, you are prompted to terminate AutoInstall. AutoInstall is a
procedure that configures a new Cisco IAD based on the configuration of an existing
Cisco IAD.
If you terminate AutoInstall, you enter the Cisco IOS software CLI.
The number of interfaces shown depends on the Cisco IAD2430 series model.
IP-Address
unassigned
unassigned
Chapter 2
OK? Method Status
NO unset up
NO unset up
Using the setup Command Facility
Protocol
up
down
OL-4306-03